Publicidad
Step 2
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in
the upper diagram below. Be prepared, the parts are greasy.
å
Fasten one EXTENSION RAIL (1) to the LEFT END (C). Use two 1/2" FLAT HEAD
SCREWS (19) through the exact holes shown.
å
NOTE: Turn a SCREW into the 1
the inner cartridge of the EXTENSION RAIL in to find the other hole that lines up
with the hole in the END. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWER.
Slide the black lever, and pull the SLIDE from the RAIL.
427328
hole shown in the enlarged diagram. Then, slide
st
2
1
Open end
www.sauder.com/service
19
1/2" FLAT HEAD SCREW
(2 used in this step)
1
1
st
C
7
1
st
Page 7
Publicidad
