Trust START-LINE ACM-250-LD Manual Del Usuario página 12

Deleting a single transmitter code
A
Press for about 1 second on the Connect button. The pairing mode will be active for 12 seconds and
the LED indicator on the receiver will flash slowly.
B
Send while the pairing mode is active with the connected Trust Smart Home transmitter an
OFF signal. If necessary, consult the instruction manual of the transmitter.
C
The LED on the module will flash to confirm that the code has been removed.
Repeat this procedure to delete several transmitters from the receiver.
Erase entire memory
A
Press the Connect button for about 8 seconds until the LED indicator flashes quickly.
B
When the LED indicator flashes rapidly, press the Connect button again shortly to confirm that you
want to completely erase the memory.
C
The LED on the module flashes to confirm that the memory has been erased.
ACM-250-LD BUILT-IN DIMMER
EN
4