Descargar Imprimir esta página

STERWINS 360 ESC Traducción De Las Instrucciones Originales página 224

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
GENERAL SAFETY INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE USE
KEEP FOR FUTURE REFERENCE
WARNING!
Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in electric shock, burns and/or severe injury.
Save all warnings and instructions for future reference.
This device is not intended to be used by persons (incl. children) with limited
physical, sensory or mental abilities or with a lack of experience and/or
knowledge unless they are supervised by a person responsible for their safety
or were instructed on the proper use of the device by that person
Children should be under supervision to ensure that they do not play with the
device
Keep the supply flexible cord away from the cutting blades.
Blades continue to rotate after machine is witched off.
Technical safety
Notes
Read the Operating Instructions carefully. Make sure to be thoroughly familiar
with the controls and proper use of the tool.
Preparation
Never allow children or other persons that are not familiar with the Operating
Instructions to use the tool. The minimum age for operating the tool may be
determined by local regulations.
Do not operate the tool while other persons – in particular children – or animals
are nearby.
Keep in mind that the operator of the tools is liable for accidents or risks that
may occur to other persons or their property.
Wear ear and eye protection while operating the tool.
Always wear sturdy foot ware and long trousers when operating the tool. Do not
operate the tool with bare feet or open sandals.
Check the area, in which out are going to operate the tool, and remover all
stones, sticks, wires, bones and other objects that may get caught and hurled
away.
Visually inspect the work tools and bolts for signs of wear and tear or damages
each time before you start using the tool. To avoid imbalance worn-out or
damaged work tools and/or bolts may only be replaced in sets.
If tools with ejection openings pointing to the back-side and uncovered rear
rollers without collection or protection devices full eye protection (safety
goggles) must be worn.
The appliance must be assembled correctly before use.
Replace worn or damaged parts for safety. Use only original spare parts. Parts
not produced by manufacturer may cause poor fit and possible injury.
Keep in mind that the operator or user is responsible for accidents or hazards
EN - 10

Publicidad

loading