Coral OSMOSIS H600 Manual De Instrucciones página 52

STEP 8: DISPLAY AND OPERATION
SECTION 1: CONTROL PANEL DISPLAY
1 Power button
2 Membrane
indicator
ON MODE The filter indicator flashes
5 times.
STANDBY/WATER DISPENSING MODE
The filter life indicator remains lit. The
life of each filter is not over, the filter
icon is bright, and the filter life shows
the percentage of the minimum life of
the filter, as shown in Figure 2. When the
filter life ends, the filter icon flashes, the
display flashes, and the percentage
icon % flashes. For example, when the
useful life of the postfilter is reached, as
shown in figure 3 .
ENERGY SAVING MODE When the system
is idle for 10 minutes, it will go into power
saving mode, all indicators will be off.
Pressing a button or opening the tap
will exit the energy saving mode.
Polyaluminium chloride
3
filter indicator
4 Filter life indicator
2 3 4
1
52
Carbon filter
5
indicator
6 Filter reset button
6
5
STANDBY MODE When you enter the
power mode for 5 seconds, press
the power button for 3 seconds, it
will switch to standby mode. It can-
not work. When the power button is
pressed for 3 seconds, it will resume its
normal activity.
WASHING STATUS In the washing state,
the 3 cartridge icons will light up in
cycles (each lighting time is 1 second),
Pre-filtration Cartridge - Post-filter -
Membrane - and so on.
FILTER RESET After resetting the filter
life, it will show the smiley face when
the filter has been reset successfully,
as shown in figure 1, then the filter life
will be shown as in figure 2.
EN