Publicidad
Lift
Agitator Up
Soulever l'agitateur
Unidad del agitador
Motor Shaft
Arbre d'entraînement
du moteur
Install
Eje del motor
New Belt
Groove
Ouverture
Ranura
Replacing Belt
Poser la nouvelle
courroie
Instalación de la correa
End Cap
Bouchon
Tapa del
extremo
Replace belt whenever a burning
rubber smell caused by excessive
slippage occurs.
Remove lower plate.
Remove agitator by carefully lifting
out.
Remove worn or broken belt.
Clean agitator.
Loop new belt (Panasonic Type UB8
only) around motor shaft and agitator
pulley; see illustration for correct belt
routing.
Reinstall agitator back into nozzle
housing grooves.
After reinstalling the agitator, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Reinstall lower plate.
- 32 -
Publicidad
