Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Condition
Pump will not start or run.
Pump will not shut off or
runs too long before water
is pumped.
Pump operates but
delivers little or no water.
If this checklist does not solve the problem, contact the Technical Service Department at
1-800-742-5044. Do not attempt to service or otherwise disassemble pump.
Care of finish: Soap and water is all that is recommended for cleaning the outside of the tank. Other
cleaning products may cause discoloration and scratching.
the pump - making sure you are not standing in water and are wearing insulated protective sole shoes.
Under flooded conditions, contact your local electric company or a qualified licensed electrician for
disconnecting electrical service prior to pump removal.
conditions. Allow 2-1/2 hours after disconnecting before attempting service.
If the above checklist does not solve the problem, contact Technical Service Department. Do not attempt
to service or otherwise disassemble pump.
the Powerflush. They may jam the pump or other plumbing lines and cause malfunction.
Possible Cause
Low voltage, open circuit,
failed capacitor
Impeller bound and cutter
bound
Motor or wiring shorted
Debris on float switch
Debris under float
Faulty float switch
Pump is air locked
Waste material has
accumulated, blocking flow of
material to pump intake
Debris around intake
Blockage in discharge pipe
Low or incorrect voltage
Damaged impeller
Incorrect float adjustment
Pump is air locked
Vertical lift too high
Before servicing a pump, always shut off the main power breaker and then unplug
Submersible pumps contain oil which become pressured and hot under operating
Do not dispose of feminine sanitary products, disposable diapers, dish rags, etc. in
Have a qualified electrician check the
circuit.
Contact Technical Service Department.
Remove debris.
Remove debris from around float.
Contact Technical Service Department.
Make sure vent hole in discharge pipe is
clear.
Hold flush handle down on toilet for 15
seconds. If unit will not clear, unplug
and wait for 30 minutes. Plug unit back
in and repeat. If unit still will not turn off,
it will need to be opened and the debris
removed.
Clean area around intake.
Remove pipe and flush out debris.
Have a qualified electrician check house
wiring.
Contact Technical Service Department.
Contact Technical Service Department.
Make sure vent hole in discharge pipe is
clear.
Change discharge piping or contact
Technical Service Department.
25
Remedy
Publicidad
