hillvert HT-HECTOR-100A Manual De Instrucciones página 24

the power supply to the unit corresponds to that specified on the identification
plate! For safety, block the wheels of the machine (e.g. by placing wedges).
WORKING CONDITIONS
Check the material to be shredded and make sure that there is enough space above
the machine to load the material. It is recommended to choose a workplace as close
as possible to where the chips are to be used. This will reduce the need to carry the
processed material to a minimum.
Keep a safe distance from the chip discharge area. Make sure that all bystanders,
children, animals, or valuables are also kept at a safe distance from the chip
discharge area.
ASSEMBLY OF THE DEVICE
The machine is delivered partially assembled, i.e. with drive unit and shredding
mechanism on the frame. Additional assembly requires the hopper (B) with its
extension (A), axle with wheels (G), outlet (E) and support (H). All these components
should be attached to the frame with the drive unit using the attached bolts or nuts
with washers - the appropriate mounting elements are attached to the individual
components of the machine. When assembling, use the included tools. It is
recommended to start assembly with the wheels (G) and the support (H).