Publicidad
Idiomas disponibles
Idiomas disponibles
FUEL: MIXTURE OF PETROL AND OIL
BE CAREFUL! This hedgetrimmer mounts a two stroke engine. Some inside parts like engine shaft's bearings and rubbing
parts between piston and cylinder need to be lubricated with a mixture of oil and petrol.
If you don't add good quality oil to the petrol in right proportion you can cause serious damage to the engine, this will inva-
lidate the warranty.
FUEL MIXTURE: Always use good quality oil suitable for two stroke air cooled engine with a 25:1 rate.
1 lt petrol mix 40ml oil
2 lt petrol mix 80ml oil
5 lt petrol mix 200ml oil
INSTRUCTION TO MAKE THE MIXTURE: Always mix petrol and oil in a clean and suitable tank. Name the tank and
mark it as the place where you store the fuel mix for your hedgetrimmer.
Use standard unleaded petrol and fill the tank with half of the requested petrol.
Pour the right quantity of oil in the tank and than add the remaining petrol.
Firmly close the gas cap and shake it to perfectly mix oil and petrol before you fill the tank of your hedgetrimmer.
PETROL
MARK
HALF PETROL
When you fill the fuel tank of your hedgetrimmer always clean the gas cap to keep it clean from debris. Always shake the fuel
tank before you fill your hedgetrimmer's tank.
Always use a hose or a funnel during the refilling to reduce the quantity of wasted fuel. Fill in the tank only up to 10-20mm,
try not to overfill the tank.
NOTE :
1.Do not mix petrol and oil directly inside the hedgetrimmer's tank.
2.Do not used oils from National Marine Manufacturer's Association (NMMA) or BIA. This kind of oil is not suitable for two
stroke air cooled engine, it does not have suitable additives and can cause serious damages to the engine.
3.Do not use oil for cars. This kind of oil does not have the suitable additives for two stroke air cooled engines and can cause
serious damages to the engine.
BE CAREFUL - DO NOT TOUCH THE SHARP SIDES OF THE BLADES .BLADES ARE EXTREMELY SHARPENED
AND VERY DANGEROUS.ALWAYS WEAR GLOVES TO PREVENT YOUR HANDS AND FINGERS TO GET
INJURED.
Adjust the blades before starting to operate with the hedgetrimmer; blades not properly fixed can vibrate and badly affect
the result of your cut.
TOO TIGHTENED BLADES CAN OVERLOAD AND DAMAGE THE DEVICE.
OIL
ADD OIL
BLADES ADJUSTMENT
AG5 HT 60R - AG5 HT 75R
15
PETROL
ADD REMAINING
SHAKE OIL
PETROL
AND PETROL
GB
Publicidad
