Publicidad
Idiomas disponibles
Idiomas disponibles
On / off button
Handle switch
WARNING: Be careful with the sharp edges of the
blades. The blades continue to rotate for a moment
after turning off the engine. Wait until the blades have
completely stopped before restarting the machine. The
blade does not stop instantly when the accelerator
trigger is released. The blade stops before 0.5
seconds after releasing the On / Off switch.
Do not start and stop the machine repeatedly in a few
seconds, it will subject the motor to important work, it
will generate enough heat and will shorten the life of
your motor and battery. We recommend that each time
the machine wait at least 5 seconds before restarting
it.
5.5. CHECKING POINTS AFTER START UP
It is important to ensure that there are no loose
parts and to check the temperature of the machine.
If you detect anything strange, stop immediately and
check carefully. In case of any anomaly or problem
take the machine to your nearest service agent for
repair. Never carry on working if the machine does not
seem to work properly.
6. MACHINE USAGE
Use this machine only for jobs for which it has
been designed. The use of this machine for any other
Safety button
Accelerator trigger
jobs is dangerous and can cause dangers to the users
and/or to the machine.
Work only with good light. Do not use this machine at
night, with fog or with reduced visibility that does not
allow you to clearly see the working area.
Limit the usage of the machine to 10 minute stints
and rest for a further 10 to 20 minutes in between
sessions.
Avoid using the machine when the ground is wet or
humid. Be especially careful when using the machine
after it has rained as the ground will be slippery and
you could fall.
If you lose your stability or if you fall, let go of the On/
Off trigger straight away.
Do not use this machine when you are tired or
under the influence of drugs, alcohol or medicines. A
moment of distraction when using this machine can
cause severe personal damage.
The lack of rest and fatigue can cause accidents and
damages.
Do not expose this machine to rain and
wet and humid conditions. If water enters
the machine there will be a higher risk of
electric shock.
Never cut above shoulder level.
Do not get near the cutting elements of the machine
when the machine is functioning.
Do not rely solely on the security elements of the
machine.
It is important to check that all parts are well
tightened. If you detect any anomaly, stop the machine
33/124
English
Publicidad
