Garland SET KEEPER40V 552 Manual De Instrucciones página 35

- Turn off the machine (if it is running).
- Release the handlebar by pulling out the locking
button (1) (this button only moves if the acelerator
trigger is not pressed, (2)).
- When you have put the handlebar in the proper
position, release the lock button.
- When the handlebar is blocked start working.
6.3. FINISHING USAGE
Once you stop using the machine, disconnect the
battery from the machine.
6.4. BATTERY CHARGE
The supply voltage and current must comply with
the information on the nameplate of the charger.
Before using the battery for the first time charge it for
at least 1 hour for the 4 Ah and 40 min for the 2 Ah
To charge the battery plug the charger into the
network, the led will light red. Place the battery in the
charger, the led will light green and start blinking. The
charger LED will change from flashing green to green
when the battery is fully charged. When the battery is
charged, remove it from the charger. If you leave the
battery in the charger and the charger is charged, the
charger will automatically turn off after 2 hours and
the led will turn green.
If you insert the battery in the charger and the LED
starts flashing red, it means that your battery is
damaged or that the battery does not correspond to
this charger.
2
Important! If you fully charge your battery,
1
disconnect it from the charger and reconnect it
without using it, the LED may start flashing red
(broken battery signal) when it detects that the battery
does not accept a charge. In this case the flashing red
LED does not mean that the battery is damaged.
Recharge the battery when you notice that the power
of your machine decreases. Avoid using the machine
until the battery is fully discharged. To check the
status of your battery, press the black button and the
green LED will light indicating your battery's charge
Black button
Notes:
- The battery will require 2 or 3 complete cycles
of charge discharge until it reaches its maximum
capacity of energy storage.
- This battery has no memory effect so it is not
necessary to discharge it completely before
reloading it.
- If you are not going to use the battery for a long
period of time, charge it to the maximum, store
it in an appropriate place and recharge it every 30
days.
Follow the following tips to ensure that the
Your battery's charge capacity remains the same
maximum possible time:
35/124
Battery charge indicators
English