Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENT LIST
1.
BATTERY PACK*
2.
CHARGER
3.
CHARGE INDICATOR LIGHT
*Not all the accessories illustrated or
described are included in standard delivery.
We recommend that you purchase your accessories
listed in the above list from the same store that
sold you the battery charger. Refer to the accessory
packaging for further details. Store personnel can
assist you and offer advice.
TECHNICAL DATA
Rated Input voltage
Output voltage
Charging current
Rated Input power
6
Charge battery
Charging time (approx.)
2.0 Ah (1pc)
2.0 Ah (2pcs)
Battery pack:
4.0 Ah (1pc)
4.0 Ah (2pcs)
Protection class
Machine weight
For the technical data of the types, the number of
cells and the rated capacity of the batteries that can
be charged, please refer the nameplate of the battery
pack supplied by Worx.
CCHARGING PROCEDURE
NOTE: Before using the tool, read the
instruction book carefully.
CHARGING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
Dual Port Battery Charger
100-240 V~50/60 Hz
20 V
2 A
50 W
Li-Ion
Approx. 65 mins
Approx. 130 mins
Approx. 130 mins
Approx. 260 mins
/II
0.5 kg
The charger is designed to charge two battery packs
at the same time as well as charge one by one.
WARNING:The charger and battery pack are
specifically designed to work together so do
not attempt to use any other devices. Never insert
or allow metallic objects into your charger or battery
pack connections because an electrical failure and
hazard will occur.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must
charge once before use.
3. HOW TO CHARGE YOUR BATTERY
CHARGING PROCEDURE
1)
Plug the charger into an appropriate outlet.
2)
Slide one battery pack or two battery packs
into the charger. Normally, the relevant charge
indicator light (3) will flash in green color
showing the battery is being charged.
WAR NIN G :
When battery charge runs out after
continuous use or exposure to direct sunlight
or heat, allow time for the battery to cool
down before re-charging to achieve the full
charge.
CHARGING INDICATOR
This charger is designed to detect some problems
that can arise with battery packs. Indicator lights
indicate problems (see table below). If this occurs,
insert a new battery pack to determine if the charger
is OK. If the new battery charges correctly, then the
original pack is defective and should be returned
to a service center or recycling service center. If the
new battery pack displays the same problem as the
original Battery Pack, have the charger tested at an
authorized service center.
Light
ON/ Flash
Red on
Red flash
- - - - -
Green on
Status
Defective Battery
Battery Temperature
Protection
The temperature of
battery pack is less
than 0
C or more than
o
45
C.
o
Fully Charged
EN
Publicidad
