IK Multimedia iLoud MTM Manual Del Usuario página 17

English
• following the audio sweeps, during the calculation process, the front LED will start to blink BLUE;
• When the process finishes, if the calibration has ended successfully, the front LED will blink GREEN
for 4 seconds and the back CAL LED will turn steady ON; if, for some reason, the calibration ended
unsuccessfully, the front LED will blink RED for 4 seconds and the back CAL LED won't turn ON. In this case
try to perform another calibration.
NOTE: the measurement signal level is independent from the volume control. The audio Sweep's level is fixed
and optimised for best performance.
Factory reset: to perform a factory reset keep pressed both the CAL/PRESET and SENS buttons for more
than 2 seconds. After this time all of the controls will be returned to the factory status and the, possibly saved,
custom Calibration will be erased.
16