Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Table 1-1 Connection LED Description
Color
LED
Green
Lights solid green when connected with the tablet via the USB cable.
Connection
Blue
Lights solid blue when connected via Bluetooth.
Table 1-2 Power LED Description
Color
LED
Yellow
Lights solid yellow automatically at power up when VCI is self-testing.
Lights solid green when powered on.
Green
Power
• Lights solid red when system failure has occurred.
Red
• Flashes red when VCI is upgrading.
Getting Started
IMPORTANT: Before operating or maintaining this unit, please read these
instructions carefully, paying extra attention to the safety warnings and
precautions. Failure to use the unit correctly may cause damage and/or
personal injury and will void the limited product warranty.
WARNING: The OTOFIX V1 Flash is compatible with OTOFIX main cable V2.0
only.
1
2
Description
Description
• Connect the OTOFIX main
cable V2.0 to the Vehicle Data
Connector on the V1 Flash
and tighten the thumb screws.
• Connect the cable's 16-pin
adapter to the vehicle's DLC,
which is generally located
under the vehicle dashboard.
3
4
BT
OR
5
• Long press the Power/Lock
button to power up the tab-
let. Ensure the tablet has a
charged battery or is connect-
ed to the supplied DC power
supply.
• Connect the tablet with the
V1 Flash via Bluetooth or the
included USB cable to estab-
lish a communication link. Use
only the USB cable connection
when programming.
NOTE: The diagnostics tablet
and the V1 Flash are config-
ured to automatically synchro-
nize with each other on the ini-
tial use, therefore, the pairing
is not required.
• When the V1 Flash is prop-
erly connected to the vehicle
and the tablet, the VCI status
button at the bottom bar on
BT
the screen displays a green
badge. This indicates your
diagnostics tablet is ready to
start vehicle diagnosis.
EN
Publicidad
