Venen Engel 6 MOBIL Manual De Instrucciones página 37

The device is intended for use in the electromagnetic environment specified below. The customer or the user of the device should assure that it is used in such an
environment.
Immunity test
Radiated RF IEC 61000-4-3
NOTE 1: At 80 MHz and 800
NOTE 2: These guidelines may not apply in all
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land mobile radios, amateur radio, AM and FM radio broadcast
and TV broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site
survey should be considered. lf the measured field strength in the location in which the Device is used exceeds the applicable RF compliance level above, the Device
should be observed to verify normal operation. If normal performance is observed, additional measures may be necessary, such as reorienting or relocating the Device. b
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than [Vii V/m].
37
Guidance and manufacturer's declaration - electromagnetic immunity
IEC 60601
test tevel
lOV/m & table 9
MHz, the higher frequency range applies.
situations. Electromagnetic propagation is affected by absorption and reflection from structures, objects and people.
Compliance level
l0V/m & table 9
Electromagnetic environment - guidance
Portable and mobile RF communications equipment
should be used no closer to any part of the
including cables, than the recommended separation
distance calculated from the equation applicable to the
frequency of the transmitter.
Recommended separation distance
d = 1.167 80 MHz to 800 MHz
d = 2.333 800 MHz to 2.5 GHz
Where Pis the maximum output power rating of the
transmitter in watts (W) according to the transmitter
manufacturer and d is the recommended separation
distance in meters (m). Field strengths from fixed RF
transmitters, as determined by an electromagnetic site
survey,should be less than the compliance level in each
frequency range. Interference may occur in the vicinity of
equipment marked with the following symbol:
Device,