Publicidad
Idiomas disponibles
Idiomas disponibles
10.3
REMOVE THE BLADE
1
3
4
1.
Push the spindle lock button to lock the spindle.
2.
Use the hex key to loosen the blade bolt
clockwise.
3.
Remove the bolt and outer flange.
4.
Use the lower guard lever to lift the lower guard
and hold the lever.
5.
Remove the blade.
10.4
CUTTING ANGLE
6
1.
Loosen the bevel lock knob (6).
2.
Use bevel scale to set the necessary angle.
3.
Tighten the bevel lock knob.
10.5
CUTTING DEPTH
5
1.
Loosen the depth adjustment knob (5).
2.
Raise or lower the base until the depth scale
reaches the required cutting depth.
3.
Tighten the depth adjustment knob.
English
10.6
2
1.
2.
10.7
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the tool and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the
battery and charger manual.
1.
2.
3.
10.8
1.
2.
11
Always wear eye protection.
9
CUTTING WIDTH
8
Loosen the width adjustment knob (8) to move
the rip-fence (7) to the necessary width.
Tighten the width adjustment knob after
adjustment.
INSTALL THE BATTERY PACK
WARNING
Align the ribs on the battery pack with the
grooves in the battery compartment.
Push the battery pack into the battery
compartment until the battery pack locks into
place.
When you hear a click, the battery pack is
installed.
REMOVE THE BATTERY PACK
Push and hold the battery release button.
Remove the battery pack from the tool.
OPERATION
WARNING
EN
7
Publicidad
