Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
11.1
START THE TOOL
The tool can not work until the lock-off button is
pushed fully to the left or right. Do not operate the
tool at low speeds for extended periods of time.
1.
Pull the trigger to turn the tool ON.
11.2
STOP THE TOOL
1.
Release the trigger to turn the tool OFF.
Release the trigger and allow the tool to come to a
complete stop.
11.3
OPERATE THE TOOL
Kickback occurs when the blade stalls quickly and the
tool is driven back to you. A step which pinches the
blade in the wood can cause blade stalling.
To prevent kickback, release switch trigger
immediately if the blade stalls.
1.
Keep the blade at the correct depth position.
2.
Examine the workpiece for nails before you cut.
Do not saw into a nail.
WARNING
1
2
NOTE
WARNING
WARNING
English
3.
Make straight cuts. Use a straight rip-fence when
rip cutting. This helps prevent you twist the blade.
4.
Use clean, sharp, and correctly set blades. Do
not make cuts with blunt blades.
5.
Support the workpiece correctly before you begin
a cut.
6.
Use stable pressure when you make a cut. Do
not force a cut.
7.
Do not cut warped or wet lumber.
8.
Hold the saw tightly and keep your body in a
balanced position to against the forces if kickback
occurs.
12
MAINTENANCE
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can
cause damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the
plastic housing or components.
Remove the battery pack from the tool before
maintenance.
12.1
CLEAN THE TOOL
The tool must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with
a vacuum cleaner.
• Do not spray the air vent or put the air vent in
solvents.
• Clean the housing and the plastic components with
a moist and soft cloth.
13
TECHNICAL DATA
Voltage
Motor
No Load Speed
Blade diameter
Max cutting Depth at 0º
Max cutting Depth at 45º
10
CAUTION
CAUTION
WARNING
CAUTION
24 V
Brushless
6500 RPM
4-1/2 '' (115 mm)
1.52 '' (38.5 mm)
1.12 '' (28.5 mm)
Publicidad
