Publicidad
Idiomas disponibles
Idiomas disponibles
1. Place the product on a sound surface and verify that all parts have been
connected properly.
2. Press the button (F) to lift the desk top. A single short press lifts the desk top
by 1 cm. A long press lifts the desk top until the button is released or the
maximum desk top height of 120 cm is reached.
3. Press the button (E) to lower the desk top. A single short press lowers the desk
top by 1 cm. A long press lowers the desk top until the button is released or
the minimum desk top height of 72 cm is reached.
4. The button [S] saves the current height setting. Press [A], followed by [B] or
[C], to save the current height setting.
5. Having adjusted the desk top to a convenient height for a sedentary posture,
press [S] to save the height setting and press [B]. The display [D] will briefly
show "H1", which means that the control box has stored the height. Now, the
product will restore the saved height setting when [B] is pressed.
6. Having adjusted the desk top to a convenient height for a standing posture,
press [S] to save the height setting and press [C]. The display [D] will briefly
show "H2", which means that the control box has stored the height. Now, the
product will restore the saved height setting when [C] is pressed.
7. To reset the product's settings, press and hold [E] for 5 seconds, until the
display shows "RES". Once this button is operated, the desk top will go to the
lowest height and then it will rise a bit. The actual height will be displayed after
the resetting process.
3.4. Cleaning and maintenance
a)
Use non-corrosive agents only for cleaning the surfaces.
b)
After each cleaning, dry all components well before the appliance is used
again.
c)
Store the appliance in a dry and cool place, protected from moisture and direct
sunlight.
d)
Do not spray the appliance with a stream of water and do not immerse it in
water.
e)
Regularly inspect the appliance for technical defects and damage.
f)
Use a soft cloth for cleaning.
g)
Clean with a soft, damp cloth.
h)
Do not clean with any sharp and/or metal implements (e.g. a wire brush or a
metal scraper) as these may damage the surface of the appliance.
Publicidad
