hillvert HT-RTT-650 Manual De Instrucciones página 51

3.5.6. Replacing The Belt
Securely prop the machine up so that the wheel on the opposite side of the engine is ~3cm off the work surface. Remove the
shear pin and wheel from belt guard side of the machine, opposite side of the engine.
Remove the 4 bolts and 1 nut on the belt guard to expose the belt assembly.
Slide the belt roller off its stud below the large transmission pulley.
Remove the belt from the engine and idler pulley: Rotate the transmission pulley and pull the belt gently through the roller
stud while working it free from the pulley.
To install a new belt, repeat the above process in reverse.
A – Pin