geberit RE 1 Manual De Instrucciones página 21

Protection degree
Mains cable length
Idling speed
Net weight
Sound pressure level at user's ear
Vibration emission value
Temperature range during operation
1) Measurement inaccuracy: 3 dB(A)
2) Measurement inaccuracy of the vibration emission value: 1.5 m/s
Note: The stated vibration emission value is measured according to a standardised test
process and can be used for comparison with other devices. The stated vibration emission
value can also be used for an introductory estimation of the interruption of use. The vibration
emission value can differ from the stated value during the actual use of the device, depending
on the way the device is used.
Commissioning
Setting the protection device
1
Unscrew wing nuts until the
protection device is loose.
2
Slide the protection device into the
required position.
I > d65
II < d65
3
Tighten the wing nuts.
9376181515 © 02-2022
964.873.00.0(02)
1)
2)
IP20
5 m
10 000-29 000 rpm
1.2 kg
79 dB(A)
≤ 4 m/s²
-20 – +60 °C
2
Setting the rotational
frequency
▶
Set the rotational frequency via the
speed controller.
A lowest rotational frequency
C average rotational frequency
G highest rotational frequency
For stainless steel pipes, set a
maximum average rotational
frequency C as decolouration can
occur.
EN
2 / 2
21