Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
Intended Use
This attachment is intended for edging around
walkways, driveways, flower beds, etc.
Action
ASSEMBLY
Connecting
Remove the existing attachment and
connect the edger attachment. Slip
the attachment into the shaft of the
main unit and secure in place with the
locking knob.
OPERATION
Starting
Press the lock-off button first, then
press the switch trigger to start the
machine.
Adjusting the depth
Loosening the adjusting knob and
move the wheel arm up to increase
the depth or down to decrease the
depth according to your work needs.
After adjustment is complete, tighten
10
the adjusting knob securely.
Note: Stop the motor and remove
the battery pack before adjusting the
depth of cut.
OPERATION TIPS
1. The edger will edge among sidewalks,
driveways, flower-beds, curbs, and similar areas.
2. Cut at a steady pace. If the blade begins to bog
down, you are edging too fast; slow your pace.
Do not force the blade into ground.
3. Light contact of the blade against the sidewalk
edge, curb, and so on, is acceptable and will not
do damage to the edger.
4. Best performance will be obtained when grass
is dry. Avoid edging in wet soil or wet grass
areas or the blade guard might clog and result
in an uneven edge. If the blade guard is clogged,
stop the machine, remove the battery pack, then
remove debris from the blade guard.
Edger Attachment
MAINTENANCE
Remove the battery from edger attachment
before carrying out any adjustment, servicing
or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls
Figure
free of dust.
FOR BATTERY TOOLS
See Fig. A
The ambient temperature range for the use
and storage of tool and battery is 0℃-45℃
（32°F-113°F）.
The recommended ambient temperature range for
the charging system during charging is 0℃-40℃
（32°F-104°F）.
See Fig. B
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
See Fig. C1,
or retailer for recycling advice.
C2
EN
Publicidad
