Publicidad
Idiomas disponibles
Idiomas disponibles
GB
GB
of the thread through the thread
outlets (45). Loosen the two thread
ends from the grooves (
spool.
6. Place the spool (45) inside the lid of
the spool cap (12) and reassemble
the lid and base.
7. Screw the spool cap (12) anticlock-
wise back onto the mounting spindle
34). Remove the hexagon so-
(
cket wrench (
8. Trim the thread line to approx. 15 cm.
Sharpen the line cutter
Never use the device without a
string cutter or defective line
cutter. There is a risk of injury.
If the thread trimming blade is
damaged, be sure to contact
our service centre.
Wear protective gloves in order to
avoid cutting yourself.
1. Switch off the engine and remove the
batteries.
2. Screw off the line cutter (13) from the
protective cover extension (14).
3. Clamp the line cutter (13) in a vice
and sharpen the knife with a flat file.
File carefully, and always in one di-
rection only.
4. Screw the line cutter (13) back onto
the protective cover extension (14).
Winding up the spool
As an alternative to a new thread spool,
you can purchase a 1.8 - 2.0 mm-thick, 5
m-long nylon thread in specialist shops
and wind this yourself onto the thread
spool.
134
46) on the
18).
1. Fold the thread in the middle and
place the middle of the thread in the
notch (47) of the spool (44).
Wind up the two ends in the direction
of the arrow, which is shown on the
topside of the spool
2. Then clamp the end of each thread
in one of the grooves (46) on the
spool (44).
Storage
•
Clean the equipment and accessories
carefully before storage.
•
Keep the equipment in a dry and dus-
tproof place out of reach of children.
•
Do not store the equipment on the
protective cover; ideally hang it from
the top handle.
•
Remove the rechargeable battery from
the device before storing the device.
•
Store the appliance in a horizontal
position or secured against toppling
over.
•
Store the 3-tooth blade (
supplied transport protection (
attached.
•
For storage, you can hang the unit at
the bottom of the motor unit.
•
Do not wrap the device in plastic bags
as moisture and mildew may form.
•
Do not lie the device down on the pro-
tective cover.
Transport
Never transport your appli-
ance while the appliance is
turned on! Risk of injury!
• Always use the protective
cover (
11) when transporting.
• Always carry the device with the cut-
ting unit pointing backwards using both
.
10) with the
11)
Publicidad
