Publicidad
Idiomas disponibles
Idiomas disponibles
To start it up, press the start button (13). A blue light will light up on the button and the control
panel (6) will light up, if they do not light up, the battery flat and you need to charge it with the
USB cable that comes with the safety seat (20), the charging voltage is 5V 1A.
When in use, the controlled settings will light up green on the control panel (6) when they are
correctly installed and red when they are not.
If all the settings are green, the safety seat is installed correctly and after five minutes the
system will switch to sleep mode.
The lights will remain on while the battery is charging.
WARNING!: Only switch it on when you want to know the status of the safety settings of the
seat, otherwise the battery will quickly go flat.
If the panel shows contradictory or questionable data, switch the electronic system off for one
minute and then switch it on again.
EN
38
Publicidad
