Publicidad
Idiomas disponibles
Idiomas disponibles
_ 2 Use for children from 100 to 125 cm using the car seat belt
Changing the safety seat into a booster seat with backrest
To switch the iTOURER safety seat into a booster seat with backrest, the seat must be in the
forward facing position. To complete the following steps the seat must be uninstalled from
the car.
• Rotate the leg by about 45 degrees. (4a)
• Press the leg support towards the base until it is fully inserted. (4b)
• Adjust the length of the leg to the shortest position by releasing the leg lock using the
buttons (4b).
• Rotate the leg towards the base until it fits into the slot. There is a lock that prevents it
from coming out. (4c)
• Fully loosen the belts by pressing the lock. (7b) (4d)
• Remove the fabric protector cover from the buckle. Lift up the backrest skirt and remove
the buckle from its slot. Refasten the belts to the buckle.
• There is a storage compartment for the buckle in the base of the seat. Open it and put
the fully fastened buckle inside. (4e)
• Close the compartment and put the backrest skirt back in place.
EN
43
Publicidad
