Clatronic HL 3800 Manual De Instrucciones página 14

Operation
Electric Connection
1. Make sure the voltage of the appliance (see rating label)
matches the mains voltage to be used.
2. Set the function control knob to 0.
3. Unwind the mains cable completely.
4. Only connect the mains plug with a properly installed
earthed socket.
Setting the Temperature
The thermostat constantly switches the fan heater on and
off, thereby keeping the temperature at the desired level.
Set the desired temperature as followed:
1. Set the temperature control to its highest setting.
2. Once the desired temperature has been reached, slowly
turn the temperature control back, until the fan heater
switches off audibly. The indicator lamp turns off.
NOTE:
The audible position of the temperature control de-
pends on the ambient temperature.
3. The fan heater will then keep the desired temperature
level.
CAUTION:
When not using the appliance, disconnect the mains plug.
Oscillation
To achieve even heating or ventilation, the appliance is
additionally equipped with an oscillation function.
There is a switch on the back of the appliance to switch the
oscillation mode on or off.
0 = Oscillation switched off
I = Oscillation switched on
CAUTION:
Never adjust the swivel mechanism with your hand. The
mechanism could be damaged.
Fan Operation
If you want to use the appliance as a fan, turn the function
control knob to the fan icon and turn the temperature control
to highest position.
End Operation
If you want to end the operation, set the function control
knob to the position 0. The indicator lamp turns off. Then
disconnect the mains plug from the socket.
14
HL3800_IM_04.2023
Overheat Protection
The appliance features an overheat protection mechanism
causing the appliance to switch off automatically in case of
overheating.
1. Set the function control knob to position 0 and pull the
mains plug out of the socket.
2. Let the appliance cool down for approx. 10 minutes
before using it again.
NOTE:
If the overheat protection mechanism causes the appli-
ance to switch off again after a short period, this might
indicate a defect.
1. Switch off the appliance and disconnect it from the
mains.
2. Have the appliance checked by your dealer or our
customer service.
Cleaning
WARNING:
• Always unplug the appliance from the mains before
cleaning and wait until the appliance has cooled down.
• Never immerse the appliance in water to clean it. This
may lead to electrical shock or fire.
CAUTION:
• Do not use wire brushes or other abrasive materials.
• Do not use caustic or scouring agents.
• Wipe away dust with a dry cloth.
• Flecks can be removed with a suitably damp cloth.
Dust on the Protective Grilles
Accumulation of dust on the protective grilles can lead to
overheating.
• Remove the dust by careful brushing.
or
• Use the upholstery nozzle of your vacuum cleaner to
remove the dust.
Storage
• Let the appliance cool down before putting it away!
• Wind the mains cable loosely.
• We recommend storing the appliance in its original
packaging if you do not intend to use it for a long period
of time.
• Always store the appliance out of the reach of children in
a well-ventilated and dry place.
22.05.23