Makita DHR183 Manual De Instrucciones página 9

To install the side grip, follow the steps below.
1. Loosen the thumb screw on the side grip.
Fig.8
► 1 . Thumb screw
2.
Install the side grip so that the grooves on the
grip fit in the protrusions on the tool while pressing the
thumb screw.
Fig.9
► 1 . Thumb screw
3. Tighten the thumb screw to secure the grip. The
grip can be fixed at desired angle.
Installing or removing drill bit
Grease
Clean the shank end of the bit and apply grease before
installing the bit.
Coat the shank end of the bit beforehand with a small
amount of grease (about 0.5 - 1 g). This chuck lubrica-
tion assures smooth action and longer service life.
1
Fig.10
► 1 . Shank end 2. Grease
1
1
2
Insert the drill bit into the tool. Turn the drill bit and push
it in until it engages.
After installing the drill bit, always make sure that the
drill bit is securely held in place by trying to pull it out.
1
Fig.11
► 1 . Drill bit
To remove the drill bit, push the chuck cover down all
the way and pull the drill bit out.
Fig.12
► 1 . Drill bit 2. Chuck cover
Depth gauge
The depth gauge is convenient for drilling holes of uniform depth.
Press and hold the lock button, and then insert the
depth gauge into the hole. Make sure that the toothed
side of the depth gauge faces the marking.
4
1 2
Fig.13
► 1. Depth gauge 2. Lock button 3. Marking 4. Toothed side
9 ENGLISH
1
2
3