Publicidad
Idiomas disponibles
Idiomas disponibles
PRESET STOPS ON THE FEEDING TABLE
Preset stops are provided to limit the height and depth of the
infeed table. To adjust the stops, follow the steps below:
1.
Make sure the machine is disconnected from the power source.
2. Loosen the two lock nuts (A) and (B) Fig. 25 and turn the
adjusting screws (C) and (D) on the back of the feed table as
necessary. A good suggestion is to install the height stop
against the pin (E) for the final cut. This means you can quickly
install the feed table for a finish or end cut without needing
to check the scale and pointer. Also, the bottom stop (C) can
be installed against the pin (E) at the maximum depth of cut
if desired.
3. Tighten the lock nuts (A) and (B) Fig. 25 after adjustment has
been made.
Fig. 25
E
A
C
SETTING THE OUTFEED TABLE
To perform accurate edging operations, the outfeed table must
be exactly level with the cutterhead blades at their highest point
in their revolution. This means that the blades should be parallel
to the outfeed table and equally projected from the cutting head.
To adjust the outfeed table, proceed as follows:
1.
Make sure that the machine is disconnected from the power
source.
2. Loosen the locking screws (A) Fig. 26 and turn the knob (B),
when the outfeed table is exactly level with the cutting head
blades at the highest point in its revolution, tighten the screws
(A).
A
Fig. 26
B
D
B
BLADE ADJUSTMENT
For accurate work, the blades must be level with the outfeed table.
If adjustment is necessary, proceed as follows:
1.
Make sure that the machine is disconnected from the power
source.
2.
Remove the set screw that holds the cutting head guard (A)
Fig. 27 in position and remove the cutting head guard.
3. Loosen the table locking handle and lower the feed table as
described in the "ADJUSTING THE FEED TABLE" section.
4. Place a steel straightedge on the outfeed table and extend it
over the cutting head as shown in Fig. 28.
Fig. 27
Fig. 25
Fig. 28
RULER
OUTPUT
TABLE
5. Carefully rotate the cutting head by hand. The blades should
lightly touch the ruler.
6. If the blade is too high or too low at either end, slightly turn
the screws located on the counter blade (D) Fig. 29 clockwise
to loosen them, using the wrench (E) provided. Then adjust
the height of the blade by turning the lifting screws (F) Fig.
31 counterclockwise to lower the blade or clockwise to raise
the blade.
Fig. 29
D
Fig. 30
A
FEED TABLE
BLADE
E
F
11
Publicidad
