Publicidad
Idiomas disponibles
Idiomas disponibles
CUTTER HEAD PULLEY GUARD ASSEMBLY
1.
Install the pulley guard (C) Fig. 13, aligning the four holes (A)
with the four holes (B) at the rear of the jointer.
2. Using the wrench provided, attach the pulley guard (C) Fig.
14 to the jointer with four M 8 Allen screws, thrust washers
and flat washers (D) as shown in Fig. 14.
Fig. 13
A
Fig. 14
D
GUIDE BRACKET ASSEMBLY INSTALLATION
1.
Attach the guide bracket assembly (A) Fig. 15 to the pulley
guard (B) using two M 8 socket head cap screws, thrust
washers and flat washers through the holes in the guide
bracket assembly, one of which is shown in Fig. 15 (C).
Fig. 15
2. Fig. 16 illustrates the guide support assembly properly
mounted on the jointer.
8
C
B
C
A
C
B
Fig. 16
SUPPORT RAIL ASSEMBLY
1.
Align the two threaded holes (G) Fig. 17 in the guide support
(A) with the two holes (C) in the guide support assembly (B)
and fasten the guide support to the guide support assembly
with two M8 Allen screws, thrust washers and flat washers
(D).
2. Fig. 18 illustrates the support rail (A) properly mounted to the
rail bracket assembly (B).
3. Screw the two support rail adjustment handles (E) Fig. 18 into
the back of the support rail (A) as shown.
Fig. 17
B
C
Fig. 18
E
B
CUTTERHEAD GUARD ASSEMBLY
1.
Remove the grub screw (not shown) from the post (A) Fig. 19
of the cutterhead guard (B).
2. Insert the post (A) Fig. 19 through the hole (C) in the feed
table.
NOTE: A spring is provided in the knob assembly (D) Fig. 20, which
returns the guard (B) onto the cutting head after the cut has been
made.
A
G
D
A
Publicidad
