Publicidad
Idiomas disponibles
Idiomas disponibles
3. Turn knob (D) to tension the spring inside the knob assembly
(D) Fig. 20 and engage into the slot in the post. If the spring
tension is too much or too little to return the cutting head
guard over the cutting head, adjust the spring tension as
necessary by removing the guard and turning the knob (D).
4. Thread the set screw (E) Fig. 20, which was removed in STEP
1, through the post (A) to hold the cutting head guard (B) in
its operating position.
5. Fig. 20 illustrates the cutting head guard (B) assembled to
the jointer.
Fig. 19
B
Fig. 20
Fig. 20
D
E
CONNECTOR ASSEMBLY FOR A DUST EXTRACTOR SYSTEM
The jointer is equipped with a dust exhaust duct (A) Fig. 21, to
efficiently eject dust during the cutting operation. If you wish to
connect a dust extraction system to your jointer, the jointer is
equipped with a dust extraction system connector (B) Fig. 21 which
can be attached to the jointer cabinet (C) with four screws (D) as
shown.
Fig. 21
C
D
A
B
A
C
B
A
CONNECTION OF THE JOINTER TO THE POWER SUPPLY
ELECTRICAL CONNECTIONS
A separate electrical circuit should be used for your tool. This
circuit should have a power cord no smaller than 12 gauge and
should be protected with a 20 A fuse. Have a Truper® Authorized
Service Center repair or replace any damaged cord immediately.
Before connecting the motor to the power source, make sure the
switch is in the off position and make sure the electrical current
of the circuit is equal to that of the machine shown on its
nameplate. Operating the motor at a lower voltage will damage
the motor.
WARNING: Do not expose the tool to rain or operate it in locations
where it may be exposed to rain.
GROUNDING INSTRUCTIONS
CAUTION: This tool must be grounded while in use to protect the
operator from electrical shock.
In the event of a malfunction or voltage drop, grounding provides
a path of least resistance to electric current to reduce the risk of
electric shock. This tool is equipped with a power cord that has a
grounding conductor and 2 current lines. The plug must be plugged
into an outlet that is properly installed and grounded in accordance
with local codes.
Improper connection of the equipment or grounding conductor
can cause a short circuit. If repair or replacement of the power
cord is necessary, do not connect the grounding conductor to a
live terminal.
Check with qualified electrician or service personnel if you do not
understand the grounding instructions or if you are in doubt as
to how to ground your tool.
The plug on the tool must match the receptacle. Never modify a
plug. Do not use any type of adapter for grounded tool plugs.
Modified plugs and different plugs increase the risk of electric
shock.
Have a damaged power cord repaired or replaced immediately by
a Truper Authorized Service Center.
This tool is designed for use on a normal 115 V~ or 230 V~ single
phase circuit.
9
Publicidad
