ALFRA 03250.L Manual De Instrucciones página 24

warning!
!
there is risk of injury with defective safety equipment.
• if the inspection of the safety shutdown equipment determined that they do not stop the unit,
bring the unit to standstill immediately.
• repair the safety shutdown equipment without delay.
• operate the unit again only after the repair work has been completed.
monthly...
• Visually inspect the blade and counter cutters for defects or breakages, and replace when necessary.
• Check the markings and warning signs on the unit for readability and damage, and replace if necessary
(see section 2.2 "Symbols on the unit").
every 6 years...
• Replace the hydraulic hose.
Maintenance, inspections and repairs must be performed by qualified electricians in accordance with the
regulations valid in the associated country.
11. dismantling and disposal
• Wear your personal protective equipment, in particular gloves and safety work shoes, also for the
dismantling and disposal of the unit (see section 2.4 "Personal protective equipment").
• To switch off the hydraulic pump, turn the mains switch to the "0" position.
• Remove the ventilation screw and close the tank opening with the screw plug to prevent hydraulic
fluid from escaping.
• Disconnect the supply cable of the foot-operated switch from the 4-pin connection.
• Disconnect the hydraulic hose from the hydraulic connection and the electrical control cable from the
electrical connection of the unit.
• When the hydraulic pump is switched off or the hydraulic system is pressurefree,
the hydraulic hose can be disconnected safely without any hydraulic fluid escaping.
The "stationary busbar cutting unit" must be properly disposed of or recycled in accordance with the
country-specific regulations.
24