WAGNER AG 14 Manual De Usuario página 4

Introduction
This airless spray gun is to be used for the high
pressure atomization of liquid coating materials.
The spray gun corresponds with Ex II 2G X and is, in
accordance with Directive 94/9/EEC (Atex 100a),
suitable for use in explosion-hazardous areas—as of
type Zone 1. Under certain circumstances, the unit
itself may cause the Zone 1 condition to be in effect.
X marking: Any static-electricity discharge from the
spray gun is to be diverted to the grounded high-
pressure pump via the conductive high-pressure hose
as stipulated.
To avoid the generation of machine sparks, prevent
impact stresses and any work on the unit with tools in
the explosion-hazardous area.
Using the Gun Trigger Lock
Always engage the gun's trigger lock when the gun is
not in use.
1. To lock the trigger, rotate the trigger lock backward
until it stops.
2. To unlock the trigger, rotate the trigger lock forward
until it is vertical.
Trigger locked
(gun will not spray)
R
GB
Trigger unlocked
(gun will spray)
Setup
Never attempt to assemble, change, or clean the
gun, tip, or tip guard without first relieving pressure
from the spray system. Follow the "Pressure Relief
Procedure" in the sprayer's Owner's Manual.
Always use a tip safety guard for added protection
against injection. Beware that the guard alone will
not prevent injection. Never cut off tip guard! Always
engage gun trigger lock when the gun is not in use.
Before servicing equipment, consult Owner's
Manuals and follow all warnings.
1. Set up the sprayer. Refer to the instructions in the
sprayer's Owner's Manual.
2. Attach a grounded, airless spray hose to the
material inlet on the gun. Using two wrenches (one
on the gun and one on the hose), tighten securely.
3. With the tip and tip
guard off the gun,
start the sprayer.
Flush and prepare the
spray system
according to the
sprayer's Owner's
Manual. Inspect the
spray system to make
sure that all fittings
are secure and that
there are no leaks.
4. Perform the "Pressure
Relief Procedure"
described in the sprayer's Owner's Manual.
4
WARNING
WARNING
Tip
Handle
Tip
Tip Seal
Retainer
© 2005 Wagner. All rights reserved.
Tip
Guard
Tip Seal