Operation Test; Drainage Way - INVENTOR COOL FCOOL-8BS Manual De Usuario

Operation test

● Plug in the power cord, then press ON/OFF on the remote controller to initiate use.
● Press the MODE button to select between AUTO, COOL, DRY, FAN or HEAT (In some models
only) and check for normal operation.
● Note: If the temperature within the area of operation, is below 16°C, this unit can not operate
under cooling mode.

Drainage way

In COOL or DRY operation, the condense water is drained to the main body, as the temperature of
■
the condenser is high, most of the condensed water will be evaporated. Usually only a minimum
amount of accumulated water would need to be drained.
When the main body of the air conditioner is full of water, the unit will beeb 8 times indicating "H8"
■
on the display panel, to alert that drainage is necessary.:
● Move unit to a suitable area for draining, while moving do not tilt the unit and always keep in an
upright position;
● Remove the drainage pipe from the plastic holder take off the rubber plug, and drain the water;
● When completed, reposition the rubber plug onto the drainage pipe and place the pipe on its
plastic holder;
● Once this procedure is completed the FULL WATER indication will turn off, and the unit will
resume operation.
Note: Allow the compressor around 3 minutes to regain operation.
22