Publicidad
Idiomas disponibles
Idiomas disponibles
Infinity
624
Fixing by screwing the motor on concrete pads
The installation is recommended in areas with heavy snowfall and where there is a risk of ooding. The principle is the same
as above, but this time the motor is raised from the ground. The height of concrete pads is decided with your judgement
Please note that in all cases, the height of the rack is directly related to the nal height of the operator.
Base support
It is imperative to never lubricate the racks
Base of support
A) Place the rst rack on the driving pinion and trace the drilling locations completely. The rack must be perfectly horizontal.
Mark a trait on the top of rack. Proceed in this way over the entire length of the gate. (Figure 10)
Note: Help yourself to use one piece of rack to stabilize 2 pieces of racks. (Figure 11)
Orificio de la
Rack hole
Cremallera
Tracking trait
Wheel
The racks provided, thermoplastic material with steel insert, are suitable
for gates with a maximum weight 600 kg. They are easily mounted on the
gate by simply screwing. We provide with self-tapping screws. If the cons-
truction of your gate doesn't allow direct mounting racks, you will have to
create a new base of support. (Figure 9)
The height of the rack should be adjusted so that the weight of the gate
won't be placed on the driving pinion. There must always be a gap from
1.5cm to 2cm between the driving motor and the rack during the stroke
of the operator.
Figure 9
Any di erence of gap above or below taking premature wear is not
covered by the product warranty.
Mounting holes
Figure 10
Opening your life
Figure 11
5
Publicidad
