Accessmatic Infinity 624 Manual De Usuario página 33

Infinity
624
Transmitter memorizing and erasing process
1) Transmitter Memorizing: Press "RF Learn" button for 2 seconds, and the LED display shows "CS"; then press the transmitte-
left button (A); the LED display will blink twice and then be o . The transmitter learning is completed.
2) Erasing Memory: Press "RF Learn" button for 5~6 seconds as right LED display is on, then wait for LED display o .
2 Sec
System learning, reset process, and led display
CAUTION: Before proceeding to system learning, the transmitter memorizing process has to be completed.
1) To Complete the System Learning:
Step1: Press "SET"; then press "SET" + "DOWN" for 3 seconds, and the LED display shows "LE""
Step2: Press left button (A) on time, the LED display should show "LP"
Step3: The gate goes to Auto-learning, please wait for the learning process to be completed
LED display
ON
Press
Push
Push 3 Sec
Press
1~3 Sec
LED display
blink twice
4 5
Opening your life
LED display OFF
Figure 16
1 2 3
6
Figure 17
1 8