Descargar Imprimir esta página

Genesis GAG1570 Manual Del Operario página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Align the small protrusion on the inside of the wheel guard band (4b) with the notch on the grinder's gear box
hub (9), then slip the guard's band onto the gear box hub. Rotate the guard to the correct position.
3. Close the lever making sure the clamp fits securely on the gear box hub.
4. If after closing the clamp the guard still moves freely, use a #2 philips screwdriver to adjust the tension on the
clamp
To Remove the Wheel Guard,
ATTENTION:
grinding wheels. Other accessories commonly used with this type of power tool may
require different types of guards. For your safety, please check with the accessory
provider concerning availability of any required guard.
WARNING:
wheel, cut-off wheel, or abrasive mop disc, the wheel guard must be fitted on the
tool so that the closed side of the guard always points towards the operator.
8
9
INSTALLING OR REMOVING DEPRESSED CENTER GRINDING WHEELS
(FIG 2)
1. Mount the inner flange (6a) with the machined "flats" side down onto the spindle. Slowly rotate the inner
flange until it engages the corresponding matching machined "flats" on the spindle shaft.
2. Slide the grinding wheel (5), crown side down and depressed side up, over the spindle shaft (8) and over the
raised shoulder on the inner flange.
3. Screw the outer flange (6b) onto the spindle with the shouldered side down.
4. firmly depress the spindle lock (3-fIG1) so the spindle cannot revolve; then use the spanner wrench (7-fIG1),
turning it clockwise, to securely tighten the outer flange.
5. To remove the wheel, follow the installation procedure in reverse.
WARNING:
the disc flange. Failure to do so will cause the grinding wheel to crack when tightening
the clamp nut. This could result in serious personal injury because of loose particles
breaking off and being thrown from the grinder. Do not overtighten.
WARNING:
wheel is on the tool. The wheel can shatter during use and the guard helps reduce the
chances of personal injury.
follow the installation procedure in reverse.
The guard included with this grinder is intended for use with
When using a depressed center grinding wheel, flex wheel, wire
Always install grinding wheel with the depressed center against
Always use the supplied guard when a depressed center grinding
6b
5
6a
4a
FIG 2
9

Publicidad

loading