Descargar Imprimir esta página

Worx WA3742 Manual Del Usuario página 6

Ocultar thumbs Ver también para WA3742:

Publicidad

Idiomas disponibles

Idiomas disponibles

ON/OFF
Light
flash
Red on
Red flash
- - - - -
Green on
Green flash
- - - - - - Charging
BATTERY TEMPERATURE PROTECTION
This charger has a battery temperature
protection feature. When the charger detects
a battery pack that is too hot or cold(the
light will be red and flash), it automatically
activates the protection circuit, and suspends
charging until the battery pack has reached
the correct temperature. The charging
6
process will then automatically begin (the
light will be green and flash). This feature
ensures maximum battery life.
LEAVING THE BATTERY PACK IN THE
CHARGER
If a fully charged battery pack is left in the
charger, the light will remain green. The
battery pack will remain charging with a
maintenance trickle current.
DEFECTIVE BATTERY PACKS
This charger will detect a defective battery
pack. When a defective battery pack is in-
serted into the charger, the charger will try to
repair it. This process will last about 30mins
(the light will be green and flash). If the repair
is successful, the charger will automatically
begin to charge the battery pack to the high-
est capacity possible (the light will be green
and flash). If the light becomes solid red, the
battery pack is dead.
NOTE: Repaired battery packs are still usable
but should not be expected to perform as
much work as new battery packs.
Battery Charger
Status
Defective Battery
Battery Temperature
Protection(less than
0
C or more than
o
45
C)
o
Fully Charged
IMPORTANT CHARGING NOTES:
1. For a new battery or a battery that has
been in storage for sometime, please
recharge the battery before use. If you
want to store the battery for a long time,
please fully charge the battery pack to
ensure maximum battery life.
2. Longer life and better performance can
be obtained if the battery pack is charged
when the air temperature is between 65°F
and 75°F (18°-24°C). Do not charge the
battery pack in air temperatures below
+ 40°F (+4.5°C), or above 105°F (40.5°C).
This is important as it can prevent serious
damage to the battery pack.
3. Never freeze your charger or immerse
charger in water or any other liquid.
4. When the battery pack fails to produce
sufficient power on jobs that were
previously done easily, please recharge
you battery, do not continue to use under
this condition. You may charge a partially
used pack whenever you desire with no
adverse affect on the battery pack.
5. When charging it is normal that the
charger and battery pack may become
warm to touch.
6. If the battery pack does not charge
properly:
a. Check current at power outlet by plugging
in another appliance.
b. Plug and unplug to check whether the
charger is ok
c. Check whether the battery has been
damaged
d. Move the charger and battery pack to
a location where the surrounding air
temperature is approximately 65°F - 75°F
(18°-24°C).
e. If the charging problem persists, take
the tool, battery pack and charger to an
authorized service center.
f.
Under certain conditions, when the
charger is plugged into the power
supply, the exposed charging contacts
inside the charger can be shorted by
foreign material. Foreign materials of
a conductive nature such as metallic
particles should be kept away from
charger cavities. Always unplug the
charger from the power supply when
there is no battery pack in the charger or
before attempting to clean.
EN

Publicidad

loading