JAROLIFT TDRC01W Instrucciones Originales página 17

ADD / COPY WALL TRANSMITTER - TDRC01W / TDRC02W
The example shown is exemplary and depends on the respective receiver type. Please follow the instructions of the
receiver!
For details, please refer to the respective instructions for the TDEF radio motors and TDR radio receivers. NOTE!
The TDEF radio motors and the external TDR receivers can be controlled with several hand-held and wall-moun-
ted transmitters. This enables, for example, individual control of the motor with a TDRC01W as well as simulta-
neous group and time control with another hand-held or wall-mounted transmitter with timer function (e.g.
TDRCT04).
To teach-in additional hand-held or wall transmitters to a radio motor or radio receiver, you need a hand-held or wall transmit-
ter that has already been taught-in (see "Initial programming").
Programming Example - Adding a TDRC02W
1. Press the UP and DOWN buttons simultaneously on a transmitter that has already been taught-in.
2. Then press the STOP button 8 times - also on the already taught-in transmitter.
3. The motor will vibrate briefly to confirm.
4. Within 10 seconds, press the UP and DOWN buttons simultaneously on the new transmitter to be learned.
5. Then briefly press the STOP button on the transmitter to be retrained. The motor will vibrate again briefly
vibrate again. The code has been copied to the new transmitter.
Transmitter already taught-in:
Press the up/
down button
simultaneous-
ly.
New transmitter to be taught:
Up/down
button simul-
taneously
press.
max. 10 sec.
max. 10 sec.
Press the stop
button 8 times
(max. 10 sec.).
(Engine vibrates)
Press the stop
button.
PROGRAMMING
max. 10 sec.
(Engine vibrates)
17