JAROLIFT TDRC01W Instrucciones Originales página 18

PROGRAMMING
SETTING THE JOG MODE
You can conveniently control blinds in the "Jog mode". When the UP button is pressed, the blinds do not immediately
does not immediately move to the upper end position. The drive is controlled by briefly pressing it and thus opens the
blind only step by step to open the slats. The function is also used for convenient control of roller shutters to open the
ventilation slits. Only when you hold down the UP button for longer than approx. 3 seconds is the drive controlled in
"self-retaining" mode and the blind is fully opened.and the blind is fully opened.
The example shown is exemplary and depends on the respective receiver type. Please observe the instructions
of the receiver!
Activating / deactivating the jog mode
1. Press the UP and DOWN buttons on the transmitter simultaneously.
2. Then press the STOP button 6 times.
3. Press the DOWN button within 10 seconds.
The motor will confirm the activation (deactivation) of the jog mode by vibrating briefly.
Taught-in transmitter:
Up/down
button si-
multaneous-
ly press.
To deactivate the jog mode, repeat the procedure.
DELETE WALL TRANSMITTER
ATTENTION!
All taught-in (programmed) transmitters are deleted! Individual deletion of a transmitter is not possible!
The example shown is exemplary and depends on the respective receiver type. Please observe the instructions
of the receiver!
1. Press the UP and DOWN buttons simultaneously on a taught-in transmitter.
2. Then press the STOP button 6 times.
3. Press the UP button within 10 seconds. The motor will confirm the deletion of the transmitters by
a short vibration.
Taught-in transmitter:
Up/down but-
ton simulta-
neously press.
18
Press
the stop
max. button 6
10 sec.
times.
6 x stop
button
max.
Press.
10 sec.
Press the
Down button
max.
1 x
10 sec.
1 x UP key
Press
max.
10 sec.
max.
10 sec.
(Engine vibrates)
max.
10 sec.
(engine vibrates)