Dometic Frigo DC VAK Instrucciones De Montaje página 9

Frigo DC VAK
Recommended tightening torques if no other tightening torque is specified:
M5
(0.80)
4 Nm to
6 Nm
5/8" 18 UNF
2 Nm to 4 Nm
7.3 Installing the DC unit
!
WARNING!
When installing the Frigo DC VAK, observe the original instructions of the vehi-
cle manufacturer and the installation manual for the Frigo DC electric cooling
system.
7.3.1 Removing the spare tire (if present)
A
NOTICE!
Make sure that the vehicle is equipped with a suitable tire repair kit if no spare
tire is carried.
Inform the vehicle owner about the removal of the spare tire.
I
NOTE
Observe the operating instructions for the vehicle when removing the spare
tire. If openings are made on the vehicle after removing the spare tire holder
and its attachments (jack), these must be closed again.
➤ Remove the spare tire from the retaining frame as described in the owner's
manual of the vehicle.
➤ Remove the existing bolt of the support frame and unhook the frame.
➤ Remove the jack for the spare tire.
➤ Close the resulting opening in the bumper.
Prepare the underbody (fig. 2)
7.3.2
➤ Bend aside the heat shield on the exhaust system silencer to make room for
the DC unit.
➤ Loosen the two fastening screws from the fuel tank.
EN
M6 M8
(1.00) (1.25)
8 Nm to 20 Nm to
12 Nm 30 Nm
3/4" 16 UNF
3 Nm to 5.5 Nm
M10 M10
(1.25) (1.50)
40 Nm to 37 Nm to
55 Nm 52 Nm
7/8" 14 UNF
4 Nm to 6 Nm
Installation
M12 M12
(1.50) (1.75)
70 Nm to 60 Nm to
90 Nm 85 Nm
1" 14 UNS
4 Nm to 6 Nm
7