Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT
Remove any obstacle before beginning work.
3. Inspect the entire unit for loose fasteners and fuel leakage. Make sure
that the cutting attachment is properly installed and securely fastened.
4. Be sure the debris guard is firmly attached in place.
■ STARTING THE ENGINE
1. Keep bystanders and animals at least 50 feet (15m) away from the
operating point. If you are approached, immediately stop the engine.
2. The product is equipped with a centrifugal clutch mechanism, so the
cutting attachment begins to rotate as soon as the engine is started by
putting the throttle into the start position. When starting the engine, place
the product onto the ground in a flat clear area and hold it firmly in place
so as to ensure that neither the cutting part nor the throttle come into
contact with any obstacle when the engine starts.
WARNING
Never place the throttle into the high speed position when starting the
engine.
3. After starting the engine, check to make sure that the cutting
attachment stops rotating when the throttle is moved fully back to its
original position. If it continues to rotate even after the throttle has been
moved fully back, turn off the engine and take the unit to your authorized
servicing dealer for repair.
■ USING THE PRODUCT
IMPORTANT
Cut only materials recommended by the manufacturer. And use only for
tasks explained in the manual.
1. Grip the handles firmly with both hands using your whole hand. Place
your feet slightly apart (slightly further apart than the width of your
shoulders) so that your weight is distributed evenly across both legs, and
always be sure to maintain a steady, even posture while working.
2. Keep cutting attachment below waist level.
3. Maintain the speed of the engine at the level required to perform
cutting work, and never raise the speed of the engine above the level
necessary.
4. If the unit start to shake or vibrate, turn off the engine and check the
whole unit. Do not use it until the trouble has been properly corrected.
5. Keep all parts of your body away from rotating cutting attachment and
hot surfaces.
6. Never touch the muffler, spark plug, or other metallic parts of the
engine while the engine is in operation or immediately after shutting
down the engine. Doing so could result in serious burns or electrical
shock.
7
Publicidad
