LiftMaster ELITE Serie Guía Rápida
Ocultar thumbs
Ver también para ELITE Serie:
- Instalación manual (52 páginas) ,
- Manual de instalacion del operador de puerta (52 páginas) ,
- Manual de instalación (48 páginas)
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
QuickStar t
for single gate application
2016 UL 325 Gate Operators require use of LiftMaster
external monitored entrapment protection devices.
This QuickStart is intended to highlight a single gate
application. Each application is unique and it is the
responsibility of the purchaser, installer and end user to ensure
that the total gate system is installed and operated properly.
Refer to the installation manual for complete information
regarding installation, testing, and programming.
845 Larch Avenue
Elmhurst, Illinois 60126-1196
LiftMaster.com
01-38285
© 2016, LiftMaster – All Rights Reserved
Determine location for concrete pad
and operator.
Dimension (A) thru (E) are from
the center of one pivot point to
the center of another pivot point.
D
minus 10" (25.4 cm)
10" (25.4 cm)
Distance
Chart A
DISTANCE
46"
35.5"
29.5"
35"
11"
45"
(116.8 cm)
(90.1 cm)
(74.9 cm)
(88.9 cm)
(27.9 cm)
(114.3 cm)
46.8"
35.5"
33.5"
42"
11"
37"
(118.7 cm)
(90.1 cm)
(85.1 cm)
(106.7 cm)
(27.9 cm)
(94 cm)
46.8"
37"
31.5"
40"
11"
41"
(118.7 cm)
(94 cm)
(80 cm)
(101.6 cm)
(27.9 cm)
(104.1 cm)
47.3"
37.3"
30"
37"
11"
45"
(120 cm)
(94.6 cm)
(76.2 cm)
(94 cm)
(27.9 cm)
(114.3 cm)
47"
35"
29.5"
32"
11"
45"
(119.4 cm)
(89 cm)
(74.9 cm)
(81.3 cm)
(27.9 cm)
(114.3 cm)
42.5"
33"
26.5"
28.5"
11"
41"
(108 cm)
(83.8 cm)
(67.3 cm)
(72.4 cm)
(27.9 cm)
(104.1 cm)
Chart B
DISTANCE
34.5"
34.8"
29.5"
35"
14"
43"
(87.6 cm)
(88.3 cm)
(74.9 cm)
(88.9 cm)
(35.6 cm)
(109.2 cm)
44"
36.5"
32.5"
42"
14"
32"
(92.7 cm)
(82.6 cm)
(106.7 cm)
(35.6 cm)
(81.3 cm)
(111.8 cm)
44"
37"
30.5"
40"
14"
40"
(111.8 cm)
(94 cm)
(77.5 cm)
(101.6 cm)
(35.6 cm)
(101.6 cm)
43"
45"
37"
30.5"
37"
14"
(114.3 cm)
(94 cm)
(77.5 cm)
(94 cm)
(35.6 cm)
(109.2 cm)
44.8"
35.8"
29.5"
32"
14"
44"
(113.7 cm)
(90.8 cm)
(74.9 cm)
(81.3 cm)
(35.6 cm)
(111.8 cm)
41"
39"
27.5"
28.5"
14"
41"
(104.1 cm)
(99.1 cm)
(69.9 cm)
(72.4 cm)
(35.6 cm)
(104.1 cm)
INSTALLATION
Install conduit and pour concrete pad.
Attach the operator to the concrete pad.
12.2" (31 cm)
6" (15.2 cm) Above
Ground
Below the frost line.
Check all national and
local codes. Minimum of
24" (61 cm)
recommended in regions
with no frost line.
28" (71.1 cm)
24" (61 cm)
Weld long arm, short arm, and gate bracket.
Position the gate bracket.
46" (116.8 cm)
Adjust the operator arm length.
Install the cover.
Publicidad
Manuales relacionados para LiftMaster ELITE Serie
Resumen de contenidos para LiftMaster ELITE Serie
- Página 1 Below the frost line. Check all national and Distance local codes. Minimum of Chart A 2016 UL 325 Gate Operators require use of LiftMaster 24" (61 cm) recommended in regions external monitored entrapment protection devices. DISTANCE with no frost line.
- Página 2 LEFT RIGHT gate is stopping at the proper open and close limit positions. system and REQUIRES the addition of a LiftMaster external 1. To set the initial handing of 1. Turn off the AC power from the main monitored entrapment protection system (non-contact photoelectric the operator, make sure that 2.
- Página 3 (29,5 po) (32 po) (14 po) (44 po) LiftMaster.com 104,1 cm 99,1 cm 69,9 cm 72,4 cm 35,6 cm 104,1 cm (41 po) (39 po) (27,5 po) (28,5 po) (14 po) (41 po) 01-38285 © 2016, LiftMaster – Tous droits réservés...
- Página 4 D’OUVERTURE piégeage et EXIGE l’ajout d’un système externe surveillé de 1. Éteindre l’alimentation CA à partir du fermeture. protection de LiftMaster contre le piégeage (capteur disjoncteur de l’alimentation principale. 1. Pour régler la direction initiale HANDING 2. Placer un objet solide entre la barrière ouverte et une structure rigide.
- Página 5 (14 pulg.) (44 pulg.) LiftMaster.com 104.1 cm 99.1 cm 69.9 cm 72.4 cm 35.6 cm 104.1 cm (41 pulg.) (39 pulg.) (27.5 pulg.) (28.5 pulg.) (14 pulg.) (41 pulg.) 01-38285 © 2016, LiftMaster – Reservados todos los derechos de ley...
- Página 6 ES NECESARIO instalar otra protección externa 1. Cortar la alimentación eléctrica con el 1. Para determinar la dirección monitoreada de LiftMaster para CADA zona de atrapamiento 2. Colocar un objeto sólido entre la trayectoria de apertura y una interruptor principal del circuito.