Control Panel • Functions - INVENTOR EP3-ION16L Manual De Usuario

6. CONTROL PANEL • FUNCTIONS
POWER
By pressing the "POWER" button the dehumidifier turns on or off. The "Power" button and Display
will turn on.
• When the room's humidity level reaches 3% -5% below the desired set humidity level,
the compressor of the unit will automatically stop, while the fan:
i) Will continue to operate for a short period of time, stopping only, if and when, the
humidity levels remain below the desired setting. This applies to models manufactured
before June 2018.
ii) Will continue to operate. Continuous fan operation is in fact more energy efficient, as
the device better identifies the relative humidity of the area, allowing the compressor
to operate much less in a 24-hour period which translates to money savings. This
applies to models manufactured after July 2018.
• In the event of a power failure the unit has an Auto Restart function. Once power is
restored, the appliance will automatically restart at the preselected settings prior to
the power failure.
MODE
By pressing the "MODE" button, various operations may be selected (Dryer, Cont., Smart).
While changing operation modes, device will make a short beep.
Dryer
Dryer mode: When this function is selected the device operates under Turbo Fan Speed.
After operating for approximately 2 hours the unit will check the room's humidity. If under
45%RH, only the fan will operate for two hours. After the 2 hours, the unit will quit dryer mode.
If over 45%RH, the unit will operate in Turbo fan Speed for 1 hour before checking the room's
humidity again. The maximum operation time set by this mode is 10 hours and can be reduced
depending on the room size and the dampness of the clothes.
• For drying clothes: place the dehumidifier in a small room and set nearby the
clothes rack. Keep doors shut and allow the dehumidifier to dry the clothes.
• For optimal results manual wringing of the clothes is suggested.
• Allow 30-50cm distance from the moist clothes.
Cont.
Continuous function: the dehumidifier operates continuously when the drainage pipe is
attached, or until the water tank is full, extracting humidity from the air. When this function is
active the indicator will turn on and the device will work constantly, disregarding the relative
humidity of the room and the desired humidity level set.
• For special humidity conditions where big amounts of condensation need to
be extracted, such as extremely moist rooms.
EN
9