Publicidad
Idiomas disponibles
Idiomas disponibles
same time when transitioning from one
anchorage to another. During the normal
course of work, only one of the PFLs
should be connected to the anchorage.
To retain 100% tie-off, one PFLs must be
connected to an anchorage at all times.
WARNING
The G2 Connector must be thoroughly
inspected and operationally tested
Confirm proper operation of the connec-
tor gate. The gate of the connector should
seat into the nose without binding and
should not be distorted or obstructed. The
gate spring should exert sufficient force
to firmly close the gate. The gate locking
mechanism must prevent the gate from
opening when closed.
WARNING
When Twin Turbo G2 Connector is
properly installed, harness webbing
MUST be captured in connector cara-
biner and webbing retainer clip. This
does not apply for H700 harness.
TABLE 1: Miller Twin Turbo G2 Connector
MODEL NO.
MFLC/
DESCRIPTION
Twin Turbo G2 Connector
with harness D-pad clip
3.7 TurboLite Flash Personal Fall
Limiters with Quick-Connect
Harness Connector.
WARNING
All Honeywell Miller Self-Retracting
Lifelines must be inspected and
tested for locking and retraction
before each use (See 5.0 Inspection
& Maintenance). The installer of the
SRL must not be exposed to a fall
hazard while mounting the unit.
IMPORTANT: While reading the
installation / use instructions, refer to
referenced pictures on pages 40-41
3.8 Horizontal Use
When installing a Self-Retracting Lifelines
for horizontal use, special considerations
and warnings apply.
The following should be considered when
mounting SRL-Ps for horizontal use:
• Only use TurboLite Edge (ANSI Class
2) models due to the likelihood of
contact with sharp edges in this
application
• Free fall distance may exceed 6ft
• Increased swing fall potential
• The locking speed of the SRL may
vary in the event of a fall due to
friction between the lifeline and the
platform edge
• The SRL may lock up quicker than the
workers walking pace and thus cause
a fall by jerking the worker off balance
MATERIAL
Aluminum, nylon plastic
11
Quick-Connect
Harness connec-
tor
(See Fig.
C3-C10 for use
instructions).
WEIGHT
6 oz. (0.23 kg) - G2
Connector w/webbing
retainer clip 0.67 oz (0.03
kg) - optional D-pad clip
Publicidad
