Publicidad
Idiomas disponibles
Idiomas disponibles
Personal Protective Equipment
EN
Miller TurboLite+ Self-Retracting
Lifelines - Personal, SRL-P
This user instruction manual covers Miller
TurboLite Personal Fall Limiters.
Thank you for your purchase of Honeywell
Miller fall protection equipment manufac-
tured by Honeywell Safety Products.
WARNING
All persons using this equipment
must read, understand and follow
all instructions. Failure to do so may
result in serious injury or death. Do
not use this equipment unless you
are properly trained.
It is crucial that the authorized person/user
of this equipment read and understand
these instructions. In addition, federal
law requires employers to ensure that all
users are trained in the proper installation,
use, inspection, and maintenance of fall
protection equipment. Fall protection
training should be an integral part of a
comprehensive safety program.
Proper use of fall arrest systems can save
lives and reduce the potential of serious
injuries from a fall. The user must be aware
that forces experienced during the arrest of
a fall or prolonged suspension may cause
bodily injury. Consult a physician if there is
any question about the user's ability to use
this product. Pregnant women and minor
children must not use this product.
1.0 Purpose
Miller Self-Retracting Devices (SRDs),
including Self-Retracting Lifelines- Personal
(SRL-P), are self-contained retractable
devices designed to be used by personnel
in applications where fall protection in
combination with unrestricted worker
mobility is needed.
2.0 Fall Protection
Requirements
2.1 General Requirements
All warnings and instructions shall be
provided to authorized persons/users.
All
authorized
reference the regulations governing
occupational safety, as well as applicable
persons/users
must
ANSI or CSA standards. Please refer
to product labeling for information on
specific OSHA regulations, ANSI and CSA
standards met by product.
Proper precautions should always be
taken to remove any obstructions, debris,
material, or other recognized hazards from
the work area that could cause injuries or
interfere with the operation of the system.
Always check for obstructions below the
work area to make sure the potential fall
path is clear.
Allow adequate fall clearance below the
work surface.
To minimize the potential for accidental
disengagement, a competent person must
ensure system compatibility.
All equipment must be inspected before
each use according to the manufacturer's
instructions. Additionally, equipment must
be inspected by a competent person, other
than the user, on a regular basis, at least
annually.
Any
product
unusual wear, or deterioration must be
immediately discarded in such a manner
as to prevent inadvertent further use.
Any equipment subject to a fall must be
removed from service.
The authorized person/user shall have
a rescue plan and the means at hand to
implement it when using this equipment.
Equipment must not be altered in any way.
Do not lubricate or attempt to repair this
device. Repairs must be performed only by
the manufacturer, or persons or entities
authorized in writing by the manufacturer.
Never use fall protection equipment for
purposes other than those for which it
was designed. Fall protection equipment
should never be used for towing or hoisting.
Environmental hazards should be considered
when selecting fall protection equipment.
Equipment must not be exposed to
environmental hazards and chemicals
which may produce a harmful effect.
Polyester should not be used in certain
chemical or acidic environments. Use in a
corrosive or caustic environment dictates
a more frequent inspection and servicing
program to ensure the integrity of the
device is maintained.
6
exhibiting
deformities,
Publicidad
