SCOPREGA GE 1800 ROMA Manual De Instrucciones página 13

WARNING
IN THE EVENT OF A POWER FAILURE DURING OPERATION, THE DEVICE IS NOT ABLE TO KEEP THE WORKING SETTINGS
STORED AND CANNOT RESTART AUTOMATICALLY WHEN POWER IS RESTORED.
9. PER SGONFIARE
1. Remove the cover opposite the deflation port by unscrewing the appropriate knobs (point 3 - fig 1)
2. Connect the hose to the inflator's INlet port (point 3 - fig 1)
3. Connect the hose to the valve of the inflatable unit. It is important to choose the correct fitting for
the valve and check that there are no air leaks. Ensure that there are no bottlenecks, obstructions or
leaks in the air path.
4. Switch on the inflator by selecting ON on the main power switch (Point 1, Figure 1).
5. Start deflation by pressing the ON/OFF button on the display (Point 5, Figure 1).
6. Switch off the inflator once deflation is complete by turning the main switch to OFF.
N.B. The inflator does not stop automatically.
ATTENTION, IN THE EVENT OF OVERHEATING DUE TO PROLONGED USE, THE INFLATOR WILL
THE INFLATOR DOES NOT TURN OFF AUTOMATICALLY. SWITCH OFF THE INFLATOR
10. TROUBLESHOOTING
PROBLEM
The power cable is not connected to
The inflator does
not start
The inflator is
stopped
The pressure sensor hose (blue) is not
The inflator does
not stop
The ARS system is
The pressure sensor hose (blue) is not
not working/ The
pressure measured
on the display does
not change
10.1 ACCESSORY WARNING
The recommended accessories when using the inflator are the original SCOPREGA ones.
The use of any accessory not recommended for this inflator can be dangerous.
AUTOMATICALLY STOP TO PREVENT DAMAGE TO ITS COMPONENTS.
ONCE THE INFLATABLE HAS BEEN COMPLETELY EMPTIED OF AIR.
POSSIBLE CAUSE
the socket
The main GREEN switch is off
The power cable is damaged
The power cable is not
connected to the socket
The main switch is off
Over-temperature
properly connected to the pump or
valve of the inflatable item
properly connected to the pump or
valve of the inflatable item
POSSIBLE SOLUTION
Connect it correctly
Press the switch
Ask the SCOPREGA service to replace
or repair the cable
Connect it correctly
Press the switch
Wait until the ARS motors cool down.
The inflator will restart automatically.
Connect the hose correctly
Connect the hose correctly
13