cecotec CONGA 5290 ULTRA T Manual De Instrucciones página 21

ENGLISH
6. CLEANING AND MAINTENANCE
Jalisco main brush
− Turn the robot around and press the main brush's release button to take the cover out.
− Take the main brush out and clean the compartment.
− Clean the main brush with the provided tools and use water and soap if necessary. Dry it
carefully before installing it again. The brush must be completely dry before installing it, as
any remaining moisture can reach the motor and damage it. Fig. 9-10.
− Place the main brush in its position and fasten the cover clip.
Recommendation
Replace the main brush every 6-12 months to ensure efficient operating (depending on the
frequency and type of use).
Wet & dry tank
Fig. 11.
− Remove the solids tank.
− Open the tank cover and empty it.
− Remove the filter and filter holder as shown in the image.
− Use the cleaning brush to clean the inside of the solids tank.
− You can clean the dust compartment with water, without immersing the tank.
− Install the dust tank back in the robot.
High-efficiency filter
Fig. 12.
Remove the high-efficiency filter and shake it to remove all the dust.
Note:
− Replace the high-efficiency filter every 3 months depending on the frequency and type of
use.
− Clean the filter periodically with a brush to avoid blockage. Do not use water or detergents.
Side brush
Fig. 13.
Remove it with a torx screwdriver and clean the side brushes regularly.
Recommendation
In order to ensure a perfect cleaning, it is suggested to replace the side brushes every 3
months, depending on the frequency and type of use.
Free-fall sensors
Fig. 14.
Clean the free-fall sensors with a soft and dry cloth regularly.
40
Warning:
Always transport the product turned off and in its original package.
It is recommended a weekly robot clean-up, depending on its use.
7. TROUBLESHOOTING
Problem
1. The robot does not start up or does not clean.
2. The robot cannot charge or return to the charging base.
3. The robot does not work properly.
4. The robot emits a strange noise during cleaning.
5. The robot does not efficiently clean or dust leaks from the robot.
6. The robot could not connect to Wi-Fi.
7. The robot did not carry out the scheduled cleaning task.
8. The robot does not return to the charging base after spot cleaning or after changing
starting position.
9. The robot does not resume cleaning.
10. The robot is always offline.
11. Connection between the mobile phone and the robot failed.
Solution
1.1. The robot cannot operate with low battery. Allow it to charge before operating it.
1.2. The room temperature is below 0ºC or above 50ºC. Operate the robot in places where the
temperature is between the specified temperature range.
2.1. There are too many obstacles near the charging base, relocate the charging base to an area
free of obstacles.
2.2. Clean the charging terminals.
2.3. Make sure the power switch is on.
2.4. The robot is too far away from the charging base, place it closer and try again.
2.5. There is very little free space around the charging base. Make sure the charging terminals
are clean.
3.1. Turn the robot off, switch it off and turn it on again.
3.2. Reset the robot by pressing the reset side button.
4. The main brush, side brush or omnidirectional wheel may have foreign matters tangled, stop
the robot and clear it up.
5.1. The solids tank is full. Empty it and clear the high-efficiency filter if it is blocked.
5.2. The high-efficiency filter is blocked, clear it.
5.3. The main brush is tangled with foreign matter, please clear it up.
6.1. Bad Wi-Fi signal. Check the Wi-Fi signal.
ENGLISH
41