Atlas Copco LSF38 S180 E Instrucciones Del Producto página 9

LSF38 S180 E/R
Lubrication
The front motor ball bearing should be lubricated with grease in conjuction with the regular overhaul of the
machine.
For flexible spindle extension – When fitting the extended spindle – apply 0.5 cm
cating Engineers LE3752" (or EP grease) at the bottom of the hole in the collet holder.
Lubricating guide
Use lubricants of good quality. The oils and greases listed in the lubrication table are examples of lubri-
cants that can be recommended.
Brand
BP
Castrol
Esso
Q8
Mobil
Shell
Texaco
Molycote
Overhaul
WARNING Overspeed could result in serious injury or death
If governor is used, check that correct governor is assembled. Careless handling may put it out of
►
order
Do not disassemble security parts, e.g. speed governor or overspeed shut-off. These parts must
►
be completely replaced when damaged
Always check the free speed of the machine after service. See Section Preparation before using
►
the die grinder
The entire machine should be checked regularly at six-month intervals. If it is in heavy duty service or not
running properly it should be taken out of service more often for inspection.
The strainer at the air inlet should be cleaned frequently to prevent clogging and decreased capacity.
Useful information
Log in to Atlas Copco www.atlascopco.com
You can find information concerning our products, accessories, spare parts and published matters on our
website.
Ergonomic guidelines
Consider your workstation as you read through this list of general ergonomic guidelines and see if you can
identify areas for improvement in posture, component placement, or work environment.
■
Take frequent breaks and change work positions frequently.
■
Adapt the workstation area to your needs and the work task.
■
Adjust for convenient reach range by determining where parts or tools should be located to avoid
static load.
EN
General purpose
Bearings
Energrease LS-EP2
Spheerol EP L2
Beacon EP2
Rembrandt EP2
Mobilegrease XHP 222
Alvania EP2
Multifak EP2
BR2 Plus
© Atlas Copco Industrial Technique AB - 9836 9632 56
Safety and operating instructions
3
of grease type "Lubri-
Air lubrication
Energol E46
Arox EP46
Chopin 46
Almo oil 525
Tonna R32
Aries 32
9