Daspi ATIZA 1000N Manual De Usuario página 25

ATIZA 1000N
CONTROL PROGRAMMING
** THE RED BUTTON IS LOCATED ON THE RECEIVING BOARD (INSTALLED HORIZONTAL TO THE
BOARD, ON THE TOP LEFT), LIKE THE LED.
We select the desired brand according to the combination of the table. Look below.
PROGRAMMING THE MANEUVER TIME
• Keep the door closed.
• Connect the panel to the electrical current.
• Press and hold the OPEN and CLOSE buttons located in the
lower left part of the control panel at the same time and for 5
seconds. Then release.
• Press OPEN, the door will begin to open until reaching the limit
switch.
• Press CLOSE, the door will start to lower until it reaches the limit
switch.
The control panel will save the programming and exit.
PROGRAM DEVICE
1- Download the "DASPI" App on: