Sew Eurodrive MOVI-C SBM Serie Instrucciones De Funcionamiento página 55

7.9 Instalación conforme a UL
NOTA
El siguiente capítulo se imprime siempre en idioma inglés, independientemente del
idioma de esta documentación, debido a los requerimientos UL.
NOTA
El adhesivo UL se debe colocar en la unidad o en las inmediaciones directas de la
unidad.
7.9.1 Field wiring power terminals
•
•
X4
7.9.2 Short circuit current rating
Suitable for use on a circuit capable of delivering not more than
•
7.9.3 Branch circuit protection
Integral solid state short circuit protection does not provide branch circuit protection.
Branch circuit protection must be provided in accordance with the National Electrical
Code and any additional local codes.
•
•
•
AC 380 V – 480 V / 500 V devices
Non semiconductor fuses (currents
Non-Semiconductor fuses Class CA, CB, CC, CD, CF, G, J, K-1, K-5, RK1, RK5, T,
can be used.
Instrucciones de funcionamiento – Módulo de freno seguro SBM para montaje en el armario de conexiones
Use 75 °C copper wire only.
Tighten terminals to in-lbs (Nm) as follows:
Supply connection
Spring terminal
Wire sizes 19 – 10 AWG
65,000 rms symmetrical amperes when protected by fuses, circuit breakers as
described in the tables below.
If you use cable cross sections that are dimensioned for a smaller current than the
rated current of the unit, make sure that the fuse is dimensioned for the used cable
cross section.
For information on selecting cable cross sections, refer to the project planning ma-
nual.
Comply with the country-specific installation regulations in addition to the above
notes.
are maximum values)
Max 100 A / 500 V
Tightening torque in-lbs (Nm)
X14
PE connection
M4: 12.39 – 14.16 (1.4 – 1.6)
SCCR: 65 kA / 500 V
Inverse-time circuit breaker (currents
are maximum values)
Max 100 A / 500 V min.
Instalación eléctrica
Instalación conforme a UL
Brake terminal
Spring terminal
Wire sizes 19 – 14 AWG
Type E Combination Motor
Controller
Siemens
3RV2041-4YA10
max. 93 A
7
55