Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
DE
EN
1.
Before using the appliance, prepare it as described in the chapter "Before
first use".
FR
2.
Press the opening button on top of the appliance.
NL
3.
Add the desired amount of clear and cold water. You need to add at least
0.5 litres of water, but no more than the maximum capacity of 1.5 litres of
IT
water. For easier orientation, you can use the scale found on the inside of
ES
the appliance. Caution: Never fill water past the „Max." mark. If you heat
PL
too much water in the appliance, boiling water may be ejected and cause
scalding.
4.
Close the lid by pressing lightly until it clicks into place.
5.
Connect the base via the power cord to the power supply (220–240 V~,
50/60 Hz).
6.
The display lights up and reads "888", and all function indicators flash
briefly.
7.
Next, select one of the following options:
Boil or heat water
8.
Press the „ON/OFF" button to switch on the device.
9.
Now press the „Mode" button repeatedly until the desired setting is
displayed. „Tea 80 °C", „Coffee 90 °C" and „Water 40 °C" are available.
10. Press and hold the „Mode" button for approx. 3 seconds to toggle or toggle
between the standard program (heating the water once) and the keep-warm
function (water is kept warm at the set temperature).
11. Briefly press the „Mode" button again until the desired setting is displayed.
12. If you do not press any buttons for about 5 seconds, you will hear a double
beep and the device will start heating the water.
13. If you accidentally start the cooking process, you can interrupt it at any time
by pressing the „ON/OFF" button.
24 von 96
Stand 27.3.2023
Publicidad
