Publicidad
Idiomas disponibles
Idiomas disponibles
EN
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
Inserting the battery into the machine (Fig. D)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (8) into the base of the ma-
chine as shown in Fig. D.
2. Push the battery forward until t clicks into place.
Removing the battery from the machine (Fig. D)
1. Push the battery unlock button (10)
2. Pull the battery out of the machine as shown in
Fig. D.
Checking the battery charging status (Fig. E)
• To check the battery charge status, push the
button (11) on the battery shortly.
• The battery has 3 LED lights indicating the
charge level.
• When none of the indicators light up the battery
is empty and must be charged immediately.
Charging the battery with the charger (Fig. E)
1. Remove the battery (8) from the machine.
2. Turn the battery (8) to upside down position and
slide it onto the charger (9) as shown in Fig. E.
3. Make sure that the battery (8) is fully inserted
into the slot.
4. Plug the charger into an electrical outlet. After
a short while the LED indicators on the charger
(13) will light up to show the charger status.
6
The charger has 2 LED indicators (13) which indi-
cate the status of the charging process
Red LED Status
Green LED status
Off
Off
Off
On
On
Off
• Fully charging a 2Ah battery may take up to 60
minutes.
• Fully charging a 4Ah battery may take up to 120
minutes.
After the battery is fully charged remove the charger
plug from the outlet and remove the battery from the
charger.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
4. OPERATION
On/Off switch (Fig. B)
• To turn on the work light, select the desired op-
erating mode (I / II) using the On/Off switch (7).
• To switch the work light off, select '0' using the
On/Off switch (7).
Operating
Luminous
Power
mode
flux
I
10W
900lm
II
20W
1800lm
Adjusting the lamp body (Fig. C)
The position of the lamp body (2) may be adjusted
over a 300° range by swiveling up and down.
1. Release the locking knobs (4) on both sides of
the lamp body (2)
2. Adjust the lamp body (2) to the desired position
3. Secure the lamp body (2) in place by tightening
the locking knobs (4) on both sides.
Charger status
No power
Standby mode:
- No battery is
inserted or,
- Battery inserted
but charging has
finished
Battery charging in
progress
Runtime
Runtime
(2Ah battery)
(4Ah battery)
4 hours
8 hours
2 hours
4 hours
WWW.VONROC.COM
Publicidad
